Storylines & Rules » e formelle que vous pouvez m

Wenn Sie hier auf Links zu eBay klicken und einen Kauf tätigen, kann dies dazu führen, dass diese Website eine Provision erhält.

Immediately after I fainted from sticker shock at the pricing of the official Sanyo PLV-Z3 projector ceiling mount ($200) Wholesale Jerseys Free Shipping , I discovered a much more affordable option. For $36.95 I could obtain a Metalcraft all steel adjustable ceiling mount off ebay.


Mounting a projector to my ceiling was much easier than I considered. Here’s how I did it.


Equipment you’ll need:


* Philips Hand Screw Driver


* Circular Degree


* EZ Anchor Stud Solvers


* Tape Measure


* Phase Ladder


Measurement up the mounting hardware: The Metalcraft mount’s ceiling plate is massive measuring 5 by five inches square with six pre-drilled holes for ceiling screws. A post descends to the projector mount plate.


How I measured my area for maximum mount placement: Bisecting the width of the room, taking into consideration the airduct Wholesale Jerseys From China , and measuring eleven and a 50 % feet from the front projector screen’s surface area in addition the 50 percent the duration of the mounting plate, I put the plate on the ceiling and marked every screw hole.


Anchored to ceiling: Put on basic safety goggles to stay away from receiving ceiling board dirt in your eyes. I eliminated the plate and drove the metal EZ Anchor Stud Solver anchors right up until they ended up flush with the ceiling. The EZ Anchors are wonderful because you never have to drill a pilot hole for the self-tapping anchors. I replaced the plate about the anchors and drove every #8 screw into its anchor. You may require an further hand to maintain the plate in location while you tighten the initial two to 4 screws.


Connect the projector plate prior to attaching to ceiling plate: Because the mount assembly breaks into two sections Wholesale Jerseys China , 1 attaching to the ceiling with a publish that screws into the adjustment plate for the projector, you can screw and tighten the hex screws and plastic bushings to the projector entire body.


Safe the projector plate to the ceiling mount: The Metalcraft ceiling mount’s submit accepts a adjustable knob screw. You will need someone to help you get the screw began even though they carry up the projector. With the screw restricted you can rotate the projector from still left to appropriate on the ceiling submit.


Fine-tuning: The Metalcraft mount allows yaw Wholesale Jerseys , pitch and rotation. With the hand tightening of knobs on the projector mount plate you can canter your projector perfectly on your projection screen. With the assist of a round bubble stage you can degree the projector from front to back and left to suitable using the corresponding thumb knobs. With projector degree you can then modify your lense up and down and to the facet for a ideal display screen fill with no keystone distortion punition.


Caveat: The Metalcraft mount is wobbly simply because of the thinness of the metallic utilised on the metal band that retains the projector mount to the ceiling mount post. When you need to have to transform interconnects or alter handbook focus and zoom the projector rocks slightly as the metallic gives. This does not result in the projector to fall out of register, even though. Hey–$36.95–what do you count on?


The Metalcraft Mounting Program for the Sanyo PLV-Z3 LCD projector (and a lot of other projector brands and designs) is a excellent discount and quite reliable. Highly advised.